CSR USB SPI CONVERTER DRIVER

The clock frequency is the same as when using the LPT programmer around 18kHz. Sign up using Facebook. Are you sure that you are working with a module which has BC3-MM chip? Probably you have problem somewhere else? The voltages itself look good. Anonymous January 22, at Anonymous June 8, at 1:

Uploader:	Vobei
Date Added:	20 July 2008
File Size:	51.61 Mb
Operating Systems:	Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads:	7994
Price:	Free* [*Free Regsitration Required]

Hello, i would like to know where i can find new firmware versions?

As you say is very hard to find the BC3 module nowaday. Sorry for late response. I'm afraid that if there isn't proper CmdSetSpeed support this programmer won't work for whole range of devices. Has anybody ub idea what might be the reason for this behaviour?

Jernej's blog: USB programmer for CSR Bluetooth chips

This isn't the actual module with the bluetooth capabilities but only a connector between the module and the computer? Anonymous October 24, at 2: I have make programmer using MB-C03 module from Modulestek. I have tried to change position 0x68, 0x69 from 0x08 0x00 bc03mm converteer 0x00 0x02 bc05mm.

By using our site, you acknowledge that you have read and understand our Cookie PolicyPrivacy Policyand our Terms of Service. I want to see if this can be used with BlueLabs for Bluetooth development or not I am a complete beginner with Bluetooth and BlueLabs right now. Here you can download psr file extracted from firmware upgrade file. The clock frequency is the same as when using the LPT programmer around 18kHz. Anonymous January 31, at 8: But if you want, I can post full psr dump extracted from real hardware.

Voltage level is ok 3,3V.

At least markings in firmware header suggest that. In your case, first should be 0xe1d3ca77 and the second is strangely enough, same as original. Nope can't find any spec on that us I recall reading somewhere in some "high level" CSR blurb they said it was a couple of Mhz but I can't find that now.

Dear Jernej, very cool project. However, it is available only for 32 bit windows probably only XP. Charly April 4, cdr I probably write about it for a reason.

BT111: RF test setup and procedures

For the hardware design, I followed the application circuit in its datasheet. Anonymous January 22, at Thank you for your support Klaus. It would be also helpful if you post full dump of pskeys somewhere so we can check them out.

I made a more thorough comparison between my and yours pskeys. But I did not get it enumerated either on linux nor on windows. I als checked the SPI clock frequency. We tried to upload it on bc5mm module with no success.

CSR Bluetooth debugger downloader burner USB to SPI USB-SPI send mass production software!

Checksum is in two places, first is at 0xd0 and second is at 0xe0. Is there anybody also trying this conveeter or has anybody an idea? IIRC you must just hit "Register" button twice. Tune June 8, at 6: How did you connect these two lines? You can find instructions here: